ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

DL360G4, External health LED is red

 
Harzl Gerry
Occasional Visitor

DL360G4, External health LED is red

Hello together

I have 2 power supply, i have changed them, i have plug the 1. then the 2. power cord! nothing change! server is always runnig an the LED isr always red!

Can you help me

Thx

Gerry
10 REPLIES
Raj_75
Regular Advisor

Re: DL360G4, External health LED is red

Power off the server. Remover one power supply. Then power on with a single power supply. If it is not o.k. again try the same process with other power supply. If same problem appears you may need to check the input AC power to the server.
Harzl Gerry
Occasional Visitor

Re: DL360G4, External health LED is red

I have tried this allready! Nothing change!
I think both Power supply are ok! An the AC Input is ok to? Any idea?

Thx
pj_11
Super Advisor

Re: DL360G4, External health LED is red

Hello,

Have you checked the LED status on the systemboard.Breakfix issue to resolve

PJ
Harzl Gerry
Occasional Visitor

Re: DL360G4, External health LED is red

Yes i have checked the onboard leds! they are all green!
pj_11
Super Advisor

Re: DL360G4, External health LED is red

Hello,

Try replacing the power converter module check for bent pins are cables seated correctly are any of the internal LEDS on.
Firmware up to date.


PJ
Harzl Gerry
Occasional Visitor

Re: DL360G4, External health LED is red

I made the firmware upgrade! is now 06/01/2005! But the same failure! LED is allready red! Next Monday a HP Partner comes to replace the power converter! Will see...

Thx
pj_11
Super Advisor

Re: DL360G4, External health LED is red

Good Luck,

May be a idea to bring a system board with him.This way you will eliminate both at the same time.

PJ
Harzl Gerry
Occasional Visitor

Re: DL360G4, External health LED is red

Thx for the tip! I will tell him...

Thx and have an nice day!
Andrew_168
Regular Advisor

Re: DL360G4, External health LED is red

Hi,
Is it a new server, if it is have you made sure the switch to enable support for the second power supply is in the correct place, also make sure the bonding with the drive cage and the daughterboard is secure, this often comes loose in transit.

Regards,

Andy
Dave_180
Valued Contributor

Re: DL360G4, External health LED is red

Is there anything in the integrated management log or event log that could point you in the right direction?