HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

DL380 Does not find drives on warm reboot - OK on cold boot

 
Dave_313
Occasional Visitor

DL380 Does not find drives on warm reboot - OK on cold boot

I've been having an issue where the DL380 i'm setting up will not find the SCSI drives when the server is rebooted. However, when the server is turned off, and back on it finds them right away. To be more specific, on a reboot it looks like it is looking for the drives as the activity lights blink every so often. One drive stays lit but the other two don't. Has anyone had these issues?
2 REPLIES
Prashant (I am Back)
Honored Contributor

Re: DL380 Does not find drives on warm reboot - OK on cold boot

Hi,

2 Updates we can go with on same server.
Firmware for controller.
BIOS of server.

Recomended :
Updated M&P Patch from Site.
Use HDD Indentifier utility from site to check for hdd, because some hdd lots shipped contain faulty hdd. so can verify it using same.

Regards,
Prashant S.
Nothing is impossible
Dave_313
Occasional Visitor

Re: DL380 Does not find drives on warm reboot - OK on cold boot

Upadted both, no effect.