ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

DL380 G3 Not seeing domain at initial logon

chris stone_1
Occasional Visitor

DL380 G3 Not seeing domain at initial logon

We have a few HP Prolient DL380 G3 server running W2K with SP3. The units are setup to auto logon to the doamin at boot up. 3 of the 7 server logon everytime rebooted. 4 of them give the "No Windows NT or Windows 2000 Domain Controller is available for domain XXX. There are currently no logon servers availableto service the logon request."
The domain is a mixed mode NT 4 PDC and BDC.
Any suggestions?
Thanks
1 REPLY
david ehret
Occasional Advisor

Re: DL380 G3 Not seeing domain at initial logon

Hello Chris,

just a simple thing : how is your ethernet switch port configuration ? Is it in Autodetect or do you force them, for example, to 100 Full ?
Here, we force them to 100 Full and, on some servers, if you do not make the same config to the NIC server (which is always the best) some do not comunicate.

That may not be the cause of your problem, but check !

david