- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Re: DL380 G4 - Trouble Shooting without opening up...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО06-20-2013 07:58 AM
тАО06-20-2013 07:58 AM
DL380 G4 - Trouble Shooting without opening up the server?
Hello all,
I have a question regardin the DL380 G4 server. On the front of the system an Amber light came on. It reffered to the system health. After looking through the manual it mentioned that I should look in the system board and check the lights.
What I want to know is that is there a way where I can diagnosis where the problem is without opening the server and since I do not have physical access to the server I can only remote in. I know the amber light is on because I saw it when I was on site. I know in solaris I can use "prtdiag" "prtconf" is there a similar command? This server is running windows 2003 server 32 bit.
Thank you very much for your help.
brian ang
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО06-20-2013 08:19 AM
тАО06-20-2013 08:19 AM
Re: DL380 G4 - Trouble Shooting without opening up the server?
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО06-20-2013 09:57 AM
тАО06-20-2013 09:57 AM
Re: DL380 G4 - Trouble Shooting without opening up the server?
You may also refer to the document тАЬProLiant DL380 G4 тАУ LEDsтАЭ for information about the LED status. Refer section "System and Health LED Combinations" for status and steps to perform:
Regards,
Vijayasarathy
Views expressed herein are my personal opinion and are not the views of HPE