ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

DL380 G4 and SmartArray6i problems

probeat
Occasional Visitor

DL380 G4 and SmartArray6i problems

Have DL380 G4, SmartArray6i (firmware 2.58) and 2xHDD in RAID 1+0 configuration

when we pull out one hard drive and put new blank one...it starts rebuilding process.. and finish ok..But when now we put another new disk it starts rebuilding process , but rebuilding fails after some time.During second rebuild we can't work anything with server because it hangs.

We tried with 4 servers and many new hard disks!
4 REPLIES
Jaragon
Frequent Advisor

Re: DL380 G4 and SmartArray6i problems

have you tried the 2.68 FW?? is the FW in the HDD's current?? what's the rebuild priority??
probeat
Occasional Visitor

Re: DL380 G4 and SmartArray6i problems

Yes we tried new firmware 2.68...not working
We tried changing priority ...didn't working
probeat
Occasional Visitor

Re: DL380 G4 and SmartArray6i problems

Does anyone have same problems?
Any solutions pls?
Daniel Leblanc
Honored Contributor

Re: DL380 G4 and SmartArray6i problems

We had the same probleme here with DL380 G4, we had to shut donw the system,reboot with out the hard drive,shut down again and the reboot with the first drive and then shut down and then reboot with the second drive. only one server out of 5 did not work until the third try!

Very wierd stuff, try it and seen if it the same trouble make sur you re BIOS ALSO is up to date.