ProLiant Servers (ML,DL,SL)
1752733 Members
5699 Online
108789 Solutions
New Discussion юеВ

Re: DL380 G4 no display

 
CPEBAR
Advisor

DL380 G4 no display

hi
i have dl380 g4
-no display and give along continuous beep
-today no beep but also no display
?? any suggestion
7 REPLIES 7
Johan Guldmyr
Honored Contributor

Re: DL380 G4 no display

Hey!

Power problems?
Any leds lit?
Any leds on the system board when powering up?

Have you tried to start it in minimal config/barebone - with as few CPU/dimm/hdd/ as possible?
CPEBAR
Advisor

Re: DL380 G4 no display

led are normal green,
power supply led also green and look like it working fine,
so how could i know if it's a power supply or power back plane problem??
CPEBAR
Advisor

Re: DL380 G4 no display

i tried to start it with minimal config. but same thing nop display- no beep - nothin
Johan Guldmyr
Honored Contributor

Re: DL380 G4 no display

If the PSU is green then probably not a psu problem. But if you can you can try to put the PSU in the other psu slot.

When you start it now, does the fans start spinning?
Pete2010
Frequent Advisor

Re: DL380 G4 no display

Is the Riloe/ilo in the right slot?
All i/o cards physically in the slots? Maybe re-seat them.
CPEBAR
Advisor

Re: DL380 G4 no display

the fans start spinning always,
again the case
the server start normally, leds all are green, <>
I reseated everything but still same

I tried PSU in the 2 slots same thing

note that if i remove all memory the system health detects that and beep,,,
?
Johan Guldmyr
Honored Contributor

Re: DL380 G4 no display

When you boot it up, would you be able to have the chassi off? Maybe there are some leds on the system board that can give some hints.

There should be a paper inside the chassi door that tells you what the leds mean.

Is this a single CPU box? Or dual? Maybe you can swap them around too?