Community
ProLiant Servers (ML,DL,SL)
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

DL380 ILO 5 issue AD logon in High Security mode

 
KenZig
Occasional Visitor

‎03-08-2019 12:14 PM

‎03-08-2019 12:14 PM

DL380 ILO 5 issue AD logon in High Security mode

Somewhat new to all this. Trying to configure ilo 5 on two new DL380. If I leave it in Production mode I can logon to the ilo through a browser using a local account and also an AD account. When I switch to High Security mode the local still works but the AD account gives me an authorization failure after entering my credentials. Any ideas? I've tried Edge, IE 11, and Chrome all with TLS 1.2 active

0 Kudos
Reply
2 REPLIES 2
ronissac
Trusted Contributor

‎03-13-2019 12:16 AM

‎03-13-2019 12:16 AM

Re: DL380 ILO 5 issue AD logon in High Security mode

Please check of the active directory is configured correctly for ILO in browser

reference : https://support.hpe.com/hpsc/doc/public/display?docId=a00018320en_us , page 125,126

 

If you feel this was helpful please click the KUDOS! Thumbs below!

Regards

Ronny


I am an HPE employee
Accept or Kudo
0 Kudos
Reply
KenZig
Occasional Visitor

‎03-14-2019 08:44 AM

‎03-14-2019 08:44 AM

Re: DL380 ILO 5 issue AD logon in High Security mode

Those instructions appear to be if you're using Kerberos. Is Kerberos a requirement to enable High Security Mode?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.