HPE Community
ProLiant Servers (ML,DL,SL)
1752604 Members
4537 Online
108788 Solutions
New Discussion

Re: DL380G6 Build via SCCM

 
garym_1
Occasional Contributor

‎10-13-2010 08:35 AM

‎10-13-2010 08:35 AM

DL380G6 Build via SCCM


hi, has anyone experienced issues when configuring disks during an SCCM PXE booted build where WinPE would fail to see the disks being configured? (diskpart states 'no fixed disks')

this seems to work/fail intermittently but normally after a fail, it would definitely work after a restart.

am using the 8.4 SSTK on WinPE 3.0 and configuring 4 or 6 disks in a RAID5 using hpacuscripting.exe -i config.xml -reset
0 Kudos
Reply
3 REPLIES 3
JBerg
Occasional Visitor

‎04-19-2011 09:07 AM

‎04-19-2011 09:07 AM

Re: DL380G6 Build via SCCM

I am having the same issue, have you resolved this?
0 Kudos
Reply
garym_1
Occasional Contributor

‎05-11-2011 06:14 AM

‎05-11-2011 06:14 AM

Re: DL380G6 Build via SCCM

no, this is not resolved and i've been informed that ideally, i need to reboot to PXE after configuring the array which isn't simple at all!
0 Kudos
Reply
JBerg
Occasional Visitor

‎08-01-2011 11:18 AM

‎08-01-2011 11:18 AM

Re: DL380G6 Build via SCCM

I was noticing that I only got the failed diskpart errors when there was an OS already on the system so I created a diskpart task to delete the C drive volume before running the array config and so far I have not seen the error.  Just figured I would pass this along for anyone else having the same issue.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.