cancel
Showing results for 
Search instead for 
Did you mean: 

DL385 Teaming

 
SOLVED
Go to solution
ericxing
Occasional Contributor

DL385 Teaming

Hi all,
I have a DL385 with 2 NICs connect to 2 Cisco2924 switches. Is there possible to create Switch Load Balancing with fault tolerance?
I created the teaming with automatic mode and only can get NFT.
If possible how do I need to configure the switch (C2924).

Thanks.
3 REPLIES 3
Patrick Terlisten
Honored Contributor
Solution

Re: DL385 Teaming

Hello,

AFAIK is this not possible, because the switch doesn't know that there is a second paths from the server to another switch. "Switch Load Balancing with fault tolerance" is only possible if all NICs in a team are connected to the same switch and the switchports set to LACP.

Best regards,
Patrick
Best regards,
Patrick
ericxing
Occasional Contributor

Re: DL385 Teaming

Thanks Patrick.
If I connected to the same switch how can I get switch fault tolerance?

regards.
Eric
Patrick Terlisten
Honored Contributor

Re: DL385 Teaming

Hello,

try this:

interface FastEthernet0/1
channel-group 1 mode active
channel-protocol lacp
!
interface FastEthernet0/2
channel-group 1 mode active
channel-protocol lacp

You need to change the interface names to you enviroment. After setting the ports to LACP, setup the team.

Best regards,
Patrick
Best regards,
Patrick