DL760 G2 RILOE in slot 9 no video on boot

[Richard Light]

Hi Everyone,

I have a variety of Proliants, most with built in ILO, but my new DL760's don't have built in ILO, so we are using the RILOE II card. As per instructions, we have put the card in slot 9 and used the 30 pin cable, but it never gives a display output to the KVM switch with the card in. I have tried different cards and different cables, no luck. Take the card out, server boots fine. Could it be firmware of RILOE II card? Could it be switches on system board? Could it be sunspots or the UFO mothership? I have beat my head against the wall for a couple of days on this.

Thanks in advance,

Rich

[Martin Breidenbach]

Ummm... sorry for asking but you DID plug the video cable on the RILOE board ?

[Richard Light]

Thanks for answer, yes I did plug in video cable on RILOE card and system board.

[Roberto Hernández Romer]

I have this server, it problem solved with the last firmwares for RILOE II and System ROMpaq.

Remember connect monitor cable at RILOE and connect only keyboard and mouse to server (not RILOE-keyboard-mouse-cable).

Next documents have information about case (i don't have links)

- DOCUMENT NUMBER: EH030213_CW01
ProLiant DL760 G2 PCI Bus Initializes At Incorrect Frequency After Warm Reboot

- DOCUMENT NUMBER: ES030321_CW01
Intermittent Video Failure May Occur While Installing RILOE II With RILOE II Firmware Version 1.02 In A ProLiant DL760 G2 Server Running Windows 2000 Server

Good luck

[Richard Light]

Roberto,

Thanks for your reply. I will try this and reply back with my results.

Best Regards,

Rich