HPE Community
ProLiant Servers (ML,DL,SL)
1753357 Members
5193 Online
108792 Solutions
New Discussion

Dip switch

 
Ayman Altounji
Valued Contributor

‎11-23-2001 04:00 PM

‎11-23-2001 04:00 PM

Dip switch

I would like to find out for Pentium III 600 MHz processor, how to set the SW1 for the Bus Setting? Cause I downloaded the reference guide, but it only show the SW1 Bus/Core Ratio Settings for Processor Speed at 300, 350, 400, 450, and 500. So for 600MHz, which one should I follow?
0 Kudos
Reply
1 REPLY 1
Mark Cloutier
Respected Contributor

‎01-06-2002 04:00 PM

‎01-06-2002 04:00 PM

Re: Dip switch

Here is the chart. Go by this:
Processor Speed
(Bus at 100MHz) 1 2 3 4
350 ON ON OFF OFF
400 ON OFF ON ON
450 ON OFF ON OFF
500 ON OFF OFF ON
550 ON OFF OFF OFF
600 OFF ON ON ON
We are here for a good time, not a long time!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.