HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Do I need to set iLO or bios for doing an off line firmware update?

 
sdad46
Occasional Contributor

Do I need to set iLO or bios for doing an off line firmware update?

DL380 G3 APPEARS to be hanging up during device discovery while attempting an off line cd based update.  I have verified the CD against the published checksum as good.  Any thing special I should be aware of to run this?

 

I have iLO enabled and secure, no ip address.  I have the bios with an erased nvram, but had to reset processor 2.

I have the pci slots empty, and all the scsi drives are pulled out, network cable plugged in.  Do I need to set iLO or bios in some specific way?