HPE Community
ProLiant Servers (ML,DL,SL)
1753987 Members
3405 Online
108811 Solutions
New Discussion

Don't power up

 
Ayman Altounji
Valued Contributor

‎03-26-2001 04:00 PM

‎03-26-2001 04:00 PM

Don't power up

My server don't power up, the power light just blink one time. What can be the problem? just before that arrived, i take off the processor board to clean it and i replace it after.

thanks
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎04-22-2001 04:00 PM

‎04-22-2001 04:00 PM

Re: Don't power up

What is the exact hardware configuration of the server? How much memory, what SCSI controllers, SCSI devices, NICs, Modems, etc, are actually installed? Remove all added hardware, clear NV-RAM and attempt to boot up. To clear NV-RAM on that server, there is a 6-position switchblock on the System I/O board. Put switch 6 to the ON position, power the unit on, then off. Put switch 6 back to the off position. You will need the System Configuraton Utility to reconfigure the server.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.