cancel
Showing results for 
Search instead for 
Did you mean: 

Don't power up

Ayman Altounji
Valued Contributor

Don't power up

My server don't power up, the power light just blink one time. What can be the problem? just before that arrived, i take off the processor board to clean it and i replace it after.

thanks
1 REPLY
Ayman Altounji
Valued Contributor

Re: Don't power up

What is the exact hardware configuration of the server? How much memory, what SCSI controllers, SCSI devices, NICs, Modems, etc, are actually installed? Remove all added hardware, clear NV-RAM and attempt to boot up. To clear NV-RAM on that server, there is a 6-position switchblock on the System I/O board. Put switch 6 to the ON position, power the unit on, then off. Put switch 6 back to the off position. You will need the System Configuraton Utility to reconfigure the server.