HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Dynamic Smart Array B120i doesn't find any supported drives

 
Riandie
Occasional Visitor

Dynamic Smart Array B120i doesn't find any supported drives

We have a DL360e Gen8.

With 2 15K SAS 450GB 653951 attached to the controller.

I tried to Config the controller with the 2 drives attached. If I start ACU and got an error code 267.

Can anyone help me with this?

2 REPLIES
Jimmy Vance
HPE Pro

Re: Dynamic Smart Array B120i doesn't find any supported drives

Make sure your running a version of ACU that supports the B120i. (if your running from the F5 prompt you should be good). Have you installed a license key for SAS drive support? 




__________________________________________________
No support by private messages. Please ask the forum!      I work for HPE

If you feel this was helpful please click the KUDOS! thumb below!   
Jimmy Vance
HPE Pro

Re: Dynamic Smart Array B120i doesn't find any supported drives

Edit to my above post, the B120i only supports SATA drives, the B320i can support both SATA and SAS.  The solution is to get SATA drives, or install a controller that supports SAS




__________________________________________________
No support by private messages. Please ask the forum!      I work for HPE

If you feel this was helpful please click the KUDOS! thumb below!