Error: Could not delete array C

[roliva]

Hello,

Throught hpacucli tool I try to delete an array with command :
ctrl slot=1 ARRAY C delete forced

and I obtain the following error message :
Error: Could not delete array C

Someone can help me ?


Thanks,

[KarloChacon]

hi

seeing this command, for clarification:

you have 3 Arrays: Array A - B - C and your trying to delete C as a Array. right?

just for information:
because that command delete can work on a controller, Array or logical drive.

for entire controller would be
Controller slot=1 delete forced

for an Array where you have 3 Array A - B - C
and you want to delete B
controller slot=1 Array B delete forced

for deleting a logical drive would
referring the Array and the logical drive in it
controller slot=1 array B logicaldrive 2


I hope this cal help
let us know anything else


regards

[roliva]

I have this configuration :

HP Array Configuration Utility CLI 7.85-18.0
Detecting Controllers...Done.
Type "help" for a list of supported commands.
Type "exit" to close the console.

=> ctrl all show config

Smart Array 6i in Slot 0 ()



Smart Array P600 in Slot 3 (sn: P92B30G9ST60HS)

array A (SAS, Unused Space: 0 MB)

logicaldrive 1 (68.3 GB, RAID 1+0, OK)

physicaldrive 1I:1:1 (port 1I:box 1:bay 1, SAS, 72 GB, OK)
physicaldrive 1I:1:2 (port 1I:box 1:bay 2, SAS, 72 GB, OK)

array B (SAS, Unused Space: 0 MB)

logicaldrive 2 (68.3 GB, RAID 0, OK)

physicaldrive 1I:1:3 (port 1I:box 1:bay 3, SAS, 72 GB, OK)

array C (SAS, Unused Space: 0 MB)

logicaldrive 3 (68.3 GB, RAID 0, OK)

physicaldrive 1I:1:4 (port 1I:box 1:bay 4, SAS, 72 GB, OK)

=>



And I would like delete array C

[KarloChacon · Accepted solution]

hi

according to your:

=> ctrl all show config


you want delete Array C in Smart Array P600 in Slot 3 which has just one logical drive so the command would be:

controller slot=3 array C delete forced

I hope this can help you
regards

[KarloChacon]

hi again

the only thing was the slot number that you can get using he command you used and also that command does not need to specific a logical drive because Array C only has one logical drive in your environment

regards