- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Error Msg On Post "Length Check Out Of Bounds"
ProLiant Servers (ML,DL,SL)
1747980
Members
4010
Online
108756
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2001 04:00 PM
05-20-2001 04:00 PM
Error Msg On Post "Length Check Out Of Bounds"
While booting up Node1 of our CL380 the following message was received during the POST after the processor check:
"Log re initialized because length check out of bounds"
Next message seen was the check of the Smart Controller followed by the "run system configuration utility F1 / F10"
At this point the machine was powered cycled, the subsequent POST and reboot went clean.
Can someone explain what caused the initial message seen?
Thanks,
Tony
"Log re initialized because length check out of bounds"
Next message seen was the check of the Smart Controller followed by the "run system configuration utility F1 / F10"
At this point the machine was powered cycled, the subsequent POST and reboot went clean.
Can someone explain what caused the initial message seen?
Thanks,
Tony
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2001 04:00 PM
05-20-2001 04:00 PM
Re: Error Msg On Post "Length Check Out Of Bounds"
More information. The post error was '180' and yes I should have asked the question in the 'hardware' forum rather than in this one.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP