Error: Unable to open the file CPQTTAC.EXE

[sirch]

When I tried to configure NIC Teaming on an NT4 TSE server (Compaq 1600). I got this error message : Error: Unable to open the file CPQTTAC.EXE. though I managed to ignore the error and finish the configuration. After restarting the server and checked the NIC Teaming Properties the STATE info is DEGRADED. Now i tried to unistall the 2 NIC cards then install it back and the driver still am getting the above error. I would like to know how am going to fix this issue. As the two NIC cards are identical Compaq Netelligent 10/100 TX( one is embedded and the other is PCI). Is there a workaround so I can make the NIC teaming succesful and the STATE status should be OK.


Any advise would be very much appreciated.

regards,
chris

[Prashant (I am Back)]

Hi,

Can you download the utility from web again and check again. Are you sure teh setup is fine, it is not corrupted.

Regards,
Prashant s.