- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Error: Unable to open the file CPQTTAC.EXE
ProLiant Servers (ML,DL,SL)
1753834
Members
7742
Online
108806
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2005 04:54 PM
09-25-2005 04:54 PM
Error: Unable to open the file CPQTTAC.EXE
When I tried to configure NIC Teaming on an NT4 TSE server (Compaq 1600). I got this error message : Error: Unable to open the file CPQTTAC.EXE. though I managed to ignore the error and finish the configuration. After restarting the server and checked the NIC Teaming Properties the STATE info is DEGRADED. Now i tried to unistall the 2 NIC cards then install it back and the driver still am getting the above error. I would like to know how am going to fix this issue. As the two NIC cards are identical Compaq Netelligent 10/100 TX( one is embedded and the other is PCI). Is there a workaround so I can make the NIC teaming succesful and the STATE status should be OK.
Any advise would be very much appreciated.
regards,
chris
Any advise would be very much appreciated.
regards,
chris
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-25-2005 09:03 PM
09-25-2005 09:03 PM
Re: Error: Unable to open the file CPQTTAC.EXE
Hi,
Can you download the utility from web again and check again. Are you sure teh setup is fine, it is not corrupted.
Regards,
Prashant s.
Can you download the utility from web again and check again. Are you sure teh setup is fine, it is not corrupted.
Regards,
Prashant s.
Nothing is impossible
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP