ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Event Log - Component: Drive Array Agent Error

Event Log - Component: Drive Array Agent Error

I have the following errors appearing in the System event log. I have tried restarting the server.
If I restart the SNMP service the problem goes away until the next restart.
The server is a ProLiant ML310 G1, running Windows Server 2003 SP1.

There are about 6 of these errors in total here are 2 examples.

Source: Storage Agents
Category: Drive Array
Event ID: 515
"Component: Drive Array Agent Error: Could not read the registry subkey: "CompaqStorage\DriveArray\SpareDrv". Cause: This error can be caused by a corrupt registry or a low memory condition. Rebooting the server may correct this error."

Source: Storage Agents
Category: Drive Array
Event ID: 515
"Component: Drive Array Agent Error: Could not read the registry subkey: "CompaqStorage\DriveArray\LogicalPerf". Cause: This error can be caused by a corrupt registry or a low memory condition. Rebooting the server may correct this error."
2 REPLIES
shanwang
Trusted Contributor

Re: Event Log - Component: Drive Array Agent Error

you try clean it event log and restart the server or sotp storage agents service.

i think error from memory.because your server's hardware configure is old and your have a lot system services so the memory resource is not enough so as to storage agents error.

Prashant (I am Back)
Honored Contributor

Re: Event Log - Component: Drive Array Agent Error

Hi,

Try two things.
Disbale compaq webmanagement services that is your management agents then monitor are you getting error and your server is working fine for a day or so.
OR
Install latest psp(proliant support pack) then check again.

Regards,
Prashant S.
Nothing is impossible