HPE Community
ProLiant Servers (ML,DL,SL)
1753705 Members
4867 Online
108799 Solutions
New Discussion

GUI will not load at console

 
Ayman Altounji
Valued Contributor

‎03-13-2001 04:00 PM

‎03-13-2001 04:00 PM

GUI will not load at console

How do you get the GUI to load using Startx.ncf after installing Netware 5 and patching to Support Pack 5? Startx.ncf runs but then the GUI will not display. This makes it impossible to install/reinstall products after the OS has been installed successfully.
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎04-29-2001 04:00 PM

‎04-29-2001 04:00 PM

Re: GUI will not load at console

Can't you just use NWConfig from the command line instead of the GUI? I try to avoid using the GUI because even on my new ML-370 with 3GB of memory the damn thing is sluggish.

I install SP's from NWConfig. I haven't tried installing/reinstalling products from it, but I can't imagine it's too hard.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.