Showing results for 
Search instead for 
Did you mean: 

Ghost and RIB

Ayman Altounji
Valued Contributor

Ghost and RIB

I have two sets of ProLiant DL360's one set with RIB installed and on set without. The problem is I made a ghost image off one of the servers without RIB. When I copy that image to a server with RIB it locks at the W2K start up even if I remove the RIB it does the same thing. Other than the RIB the servers are the same. Are there ant special steps I need to take after removing the RIB?
Sunil Jerath
Honored Contributor

Re: Ghost and RIB

First of all we do not support Imaging/Cloning of drives. Secondly whenever a Hardware change takes place in a COMPAQ Server it is imperative that System Configuration Utility be run by going in F10 System partition. By doing this System is made aware of a Hardware change. If you need further assistance please contact our Tech Support at 1-800-OK-COMPAQ.