HP C3000 Power Supply problem

[bbcreation]

Hello gentlemen and ladies. HP in debug reports this to me. In the GUI itself everything is ok, the logs are clean. What could this mean? It goes on like this all the time.

Jan 27 20:06:41 OA: Input power supply type has been determined as AC power supply

Jan 27 20:06:52 OA: FRU header read failed:usei2c=1h off=0h sz=8 (slotOrBus=30 sa=A8h)

Jan 27 20:07:01 OA: Input power supply type has been determined as AC power supply

[AmRa]

Hi 

i2c is the communication bus and the errors seem to indicate that there is data that cannot be read from the power supplies. 

These event usually you will find in OA debug log which is used by HPE support team for troubleshooting purpose.

For any hardware issue you can refer OA syslog.