HP DL380 G6 Smart Start don't pickup Array Controller

[Koenrad]

Hi All

Please help. If i insert the smart start cd to config my drives it gives me a error that says it can't pickup a supported array controller.

[mabu]

Installed Controller?

You can see the Controller initialization on Boot Screen ?

[Koenrad]

Hi

Yes it's HP Smart Array P410

[mabu]

Smartstart Version ? 8.30 ?

[Erdogan Temur]

Hi,

1- F9 with in to RBSU
2- Boot Controller Order : Enter
3- Ctrl:1 Hp Smart Array P410 Controller let set.
4- Save and Exit.

Try to install

[Koenrad]

Yip 8.30 and i did done the F9 option

[mabu]

You can try the offline ACU

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&swItem=MTX-f0790470403f4da3bd94126308&jumpid=reg_R1002_USEN

then i would try a minimal configuration without HDD´s.

[Koenrad]

thanx mabu will try this

[mabu]

no problem, let me know if the ACU show the Controller, but i think the p410i is onboard and can´t remember me to had any problems with smartstart Dl380g6.

After this you can try to build a little array without the ACU. Then start the ACU and take a look. If the Array not there i would replace the Controller/Board.