HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

HP DL380 G6 Smart Start don't pickup Array Controller

 
Koenrad
Occasional Contributor

HP DL380 G6 Smart Start don't pickup Array Controller

Hi All

Please help. If i insert the smart start cd to config my drives it gives me a error that says it can't pickup a supported array controller.

8 REPLIES
mabu
Occasional Advisor

Re: HP DL380 G6 Smart Start don't pickup Array Controller

Installed Controller?

You can see the Controller initialization on Boot Screen ?
Koenrad
Occasional Contributor

Re: HP DL380 G6 Smart Start don't pickup Array Controller

Hi

Yes it's HP Smart Array P410
mabu
Occasional Advisor

Re: HP DL380 G6 Smart Start don't pickup Array Controller

Smartstart Version ? 8.30 ?

Re: HP DL380 G6 Smart Start don't pickup Array Controller

Hi,

1- F9 with in to RBSU
2- Boot Controller Order : Enter
3- Ctrl:1 Hp Smart Array P410 Controller let set.
4- Save and Exit.

Try to install
Kind Regards,
Erdogan.
I am HPE Employee

If this helps you with your issue, please click the thumb to register a Kudo.
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.
Koenrad
Occasional Contributor

Re: HP DL380 G6 Smart Start don't pickup Array Controller

Yip 8.30 and i did done the F9 option
mabu
Occasional Advisor

Re: HP DL380 G6 Smart Start don't pickup Array Controller

Koenrad
Occasional Contributor

Re: HP DL380 G6 Smart Start don't pickup Array Controller

thanx mabu will try this
mabu
Occasional Advisor

Re: HP DL380 G6 Smart Start don't pickup Array Controller

no problem, let me know if the ACU show the Controller, but i think the p410i is onboard and can´t remember me to had any problems with smartstart Dl380g6.

After this you can try to build a little array without the ACU. Then start the ACU and take a look. If the Array not there i would replace the Controller/Board.