cancel
Showing results for 
Search instead for 
Did you mean: 

HP ML 310 G5

 
onit
Occasional Visitor

HP ML 310 G5

My HP server raid controller is displaying a message "Ready for recovery, logical drive 1" however, the two hard drives i have in my Raid 1 setup seem to be fine. Any ideas why it's asking to be recovered?
1 REPLY

Re: HP ML 310 G5

Hi,

reboot the server, it was display after initialize Smart Array Controller as:

1786-Slot 0 Drive Array Recovery Needed.
The following disk drive(s) need Automatic Data Recovery (Rebuild):
Port 1I: Box x: Bay x
Select "F1" to retry Automatic Data Recovery
Select "F2" to continued without starting Automatic Data Recovery
(RESUME = "F1" OR "F2" KEY [default = "F1" in 2 seconds]

That will also fix the problem :) Remember to assign points to answers that helped in your problem. So the forum stays alive...
Kind Regards,
Erdogan.
I am HPE Employee

If this helps you with your issue, please click the thumb to register a Kudo.
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.