HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

HP ML10 Gen9 Data Source for HP SMH

 
dnlvry
Occasional Contributor

HP ML10 Gen9 Data Source for HP SMH

I've recently installed Server 2016 on a HP ML10 Gen9 but unable to install a data source for HPE System Management Homepage.

I've installed SMH 7.6.0.11 and tried installing WBEM 10.30.0.0 providers, it says during the install that they are not installed but is supported but then fails to install.

The log reports: "Executing MSI...hpwbemproviders_x64.msi... Error: CheckServerAndDependency failed. Probable Cause: Check if the expected iLO drivers are installed.
Failed!"

There are no outstanding drivers on the server to install and even if I try and install iLO 3/4 Management Controller Driver v3.2.0.0 it cannot install because the required hardware is not present.

What do I need to install to get SMH to report system health on this server?

3 REPLIES
dnlvry
Occasional Contributor

Re: HP ML10 Gen9 Data Source for HP SMH

Does anybody have a resolution to this? I thought it should be relatively simple compared to my experience with other HP ProLiant ML Servers but not with this one.

Ken Green
Advisor

Re: HP ML10 Gen9 Data Source for HP SMH

Does the ML10 Gen9 have the relevent HW for the SMH to manage? It doesn't have an iLO or a SmartArray.

dnlvry
Occasional Contributor

Re: HP ML10 Gen9 Data Source for HP SMH

@Ken Green Thanks for the reply, I understand it doesn't have a HP array but an Intel one - should I also be using Intel tools to monitor the hardware then?