Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

HP ML110 G4 Embedded RAID gone haywire

Highlighted
tpanicos
Occasional Contributor

HP ML110 G4 Embedded RAID gone haywire

Hi,

 

Wondering if there is anyone that can point me out in the right direction.

 

I have a HP ML110 G4 and I am using the Embedded SATA RAID Controller and currently have to Arrays configured.

 

1. RAID 0 - 2 x 250Gb

2. RAID 0 2 x 750Gb

 

Last night we had a power cut for a good few hours and when I tried this morning to turn it on, during boot, the drives are all detected and are 'Healthy' but the Arrays are coming up as Failed.

 

When I go into the Array Config Utility and choose either of the arrays, again, the array members are detected correctly but I noticed that one of the array members (in both seperate arrays) is in grey font and the other is white.

 

Can anyone please help point me in the direction as of what to do to get my system up and running again?

 

Thanks