ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

HP ML150G6 - 510-BMC Sel is Full

 
SOLVED
Go to solution
Filippo Viglianisi
Occasional Visitor

HP ML150G6 - 510-BMC Sel is Full

When starting my server I receive this message

BMC Responding
510-BMC Sel is Full

Then I accessed the BIOS but I didn't found the way to clear the BMC log.

How can I clear the log??

Thanks a lot for your answers
2 REPLIES
Solution

Re: HP ML150G6 - 510-BMC Sel is Full

Hi,

1. Boot the server and press the F10 key when prompted to run BIOS Setup.
2. Select the "Advanced" menu.
3. Scroll down to "IPMI" and press the ENTER key
4. Scroll down to the System Event Log and press the ENTER key.
5. At the "Clear System Event Log" selection, press the ENTER key to toggle between "Enable" and "Disable."
6. Select "Enable."
7. Press the F10 key to Save the changes and exit the BIOS Setup

That will also fix the problem :) Remember to assign points to answers that helped in your problem. So the forum stays alive...
Kind Regards,
Erdogan.
I am HPE Employee

If this helps you with your issue, please click the thumb to register a Kudo.
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.
raggimarteins
Occasional Visitor

Re: HP ML150G6 - 510-BMC Sel is Full

We have had a problem with this kind of server and it stops frequently.  When I saw this message I did what the solution told, cleared the system log in biom (BMC).  Could that cause the system stop?  There was something about CPU fan..