HP ProLiant DL360 server and RAID 6

[fess]

I have HP ProLiant DL360 server with RAID 5 (HP Smart Array E200 Controller).
OS - Ubuntu 16.04 LTS.

The output  hpacucli ctrl slot 0 = show  gives the result:

Smart Array E200i in Slot 0 (Embedded)
Bus Interface: PCI
Slot: 0
Serial Number: PR78MV1116
Cache Serial Number: P9A3A0B9SU35MY
RAID 6 (ADG) Status: Disabled
Controller Status: OK
Hardware Revision: A
Firmware Version: 1.86
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 15 secs
Surface Scan Mode: Idle
Post Prompt Timeout: 0 secs
Cache Board Present: True
Cache Status: OK
Cache Ratio: 50% Read / 50% Write
Drive Write Cache: Enabled
Total Cache Size: 128 MB
Total Cache Memory Available: 96 MB
No-Battery Write Cache: Disabled
Cache Backup Power Source: Batteries
Battery/Capacitor Count: 1
Battery/Capacitor Status: OK
SATA NCQ Supported: False

But I do not understand the line "RAID 6 (ADG) Status: Disabled". As far as I know, HP Smart Array E200 Controller does not support RAID 6. Why displays information about it?

[Torsten.]

This is probably the standard message from the tool if RAID6 is not available for any reason.

In this case with e200 it is not available at all...

[fess]

Thank you!

Can you tell about line SATA NCQ Supported: False ?

Is it possible to set up NCQ on this controller?

[Torsten. · Accepted solution]

http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c01800086&sp4ts.oid=254940&lang=en-ca&cc=ca

The following Smart Array Controllers cannot be upgraded to use NCQ due to hardware limitations:

• Smart Array E200
• Smart Array P600

[fess]

Thank you!