HP ProLiant ML350 G6 - F8 to access iLO2 setup doesn't appear

[GonzaloMDP]

Hi:
We have a HP Proliant ML350 G6 server. We disable the iLO 2 on this server due to constant error messages into Windows event log and since then, the fans started to spin faster than usual. Then we wanted to re-enable iLO 2; for this:
* Turn off the Server
* Set the Switch S1 in position ON
* Wait for the message "press F8 to access RBSU"  appeared, however it never did. The F8 key, however, leads us to the ROM configuration for Array Utility.

We send pictures of boot screens.

Hope you can help. Thank you

[Suman_1978]

Hi,

Some suggestions:

1. Clear NVRAM from System Maintenance Switch.

If clearing NVRAM does not work.

2. Update BIOS and iLO Firmware and see if that makes a difference.

https://h20565.www2.hp.com/portal/site/hpsc/template.PAGE/public/kb/docDisplay/?docId=mmr_kc-0108967

Thank You!
I am a HP employee.