ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

HP Proliant DL380 G5 after update BIOS

Max Belov
Occasional Visitor

HP Proliant DL380 G5 after update BIOS

After update BIOS the computer is started, but on the screen is deduced nothing. RAID the controller defines disks (it is visible on consistently lighting up bulbs). Bulbs on the keyboard blink at the first inclusion and do not light up any more. Each ~30 seconds single peep dynamics is audible. More occurs nothing.

Help to restore server please =(
1 REPLY
Max Belov
Occasional Visitor

Re: HP Proliant DL380 G5 after update BIOS

1. Power down the server (on page 27).
2. Remove the access panel ("Removing the access panel" on page 29).
3. Set positions 1, 5, and 6 of the system maintenance switch to On.
4. Install the access panel ("Installing the access panel" on page 29).
5. Power up the server (on page 27).
6. Wait for the server to emit two beeps.
7. Repeat steps 1 and 2.
8. Set positions 1, 5, and 6 of the system maintenance switch to Off.
9. Repeat steps 4 and 5.
When the server boots, the system identifies whether the current ROM bank is corrupt. If a corrupt ROM is detected, the system boots from the backup ROM and alerts you through POST or IML that the ROM bank is corrupt.
If both the current and backup versions of the ROM are corrupt, the server automatically enters ROMPaq disaster recovery mode.



it's not work =(