ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

HP Proliant DL380 Reboot problem

 
Joackim_1
Occasional Contributor

HP Proliant DL380 Reboot problem

Can anyone urgently assist. My DL380 Server keeps on rebooting. Upon checking the event log the following are the error message shown:

The system encountered a Non-Maskable Interrupt (NMI) prior to this boot. The NMI source was: PCI bus error, slot 0.
2 REPLIES
Oleg Koroz
Honored Contributor

Re: HP Proliant DL380 Reboot problem

how often ?
pull all PCI cards OUT
Clear NVRAM
run Firmware CD 7.40B from cold boot
chances SYS BRD or Array if onboard

http://h18023.www1.hp.com/support/files/server/us/index.html
kesaco
Occasional Advisor

Re: HP Proliant DL380 Reboot problem

What is the revision of the pci riser board ? The revision must be A or C ( or higher ). PCi riser boards Revision B are not reliable. However, a workaround exists in waiting for to order a new board : move one of the 64-bit cards to the 32-bit PCI slot or install a 32-bit card in one of the 64-bit PCI slots. It could be fine.

Regards,
Kesaco