HP iLO v4

[Niroa]

We have HP proliant 350ML gen8 server and centos installed in it.

Yesterday morning it stop internet connecting process. Every time server restart I see iLO v 4 IP unknown.

then I set iLO to default. but no good thing happened.  When I restart the server the internet connection is back to normal, but after 2 minutes it is getting lost.

I disabled HP iLO by pressing F8 and disabled. Now the F8 option is invisible and nothing happens when I press F8.

How to re-enable iLO in my HP server?

[Torsten.]

I don't understand if your network problem is with OS or ILO.

However, to enable ILO again toggle dip switch 1 at the system maintenance switch on the system board.

[Jimmy Vance]

---

@Niroa wrote:

Yesterday morning it stop internet connecting process. Every time server restart I see iLO v 4 IP unknown.

---

iLO v4 IP unknown generally means you dont have iLO connected to the network, or there isn't a DHCP server on the network to provide an IP to iLO.  iLO connectivity has nothing to do wth the host OS not being able to communicate with the network.

---

@Niroa wrote:

I disabled HP iLO by pressing F8 and disabled. Now the F8 option is invisible and nothing happens when I press F8.
How to re-enable iLO in my HP server?

---

To re-enable iLO on a Gen8 ProLiant:

1) Power off system and remove power.  Open case and set sw1 of the maintenance switch to the ON position. refer to decal inside case cover for position of switch.

2) power system on and press F8 to access iLO when prompted. under Settings - Confuigure ENABLE iLO Functionality and iLO4 ROM based Setup Utility

3) Exit and once iLO resets and the server continues through POST, power off, set SW1 back to off.

4) After replacing case cover, power server back on

[Niroa]

i enabled it. thanks very much. but still ip status is unknown in bios.

MY CONFIG IS :

1. DHCP enabled

2. selected public ethernet adapter in intelligent Provisioning.

[Torsten.]

Do you have a DHCP server that can serve the DHCP request?

[Niroa]

yes, the router

[Jimmy Vance]

Do you have a network cale pluggend into the iLO network port?  Is iLO in dedicated (default) or shared network mode? If I recall that server has two embedded NICs for the Host OS, and one dedicated port for iLO

[Niroa]

No. there is no iLO port. Only two network ports for eth1 and eth2.

But there is an iLO ip version at the boot process.

Sorry for the comment hearder. We have HP proliant ML310e gen8 server.

sorry for the inconvenience.

[Torsten.]

The dedicated port for ML310e Gen8 is optional, for ML310e Gen8 v2 is is always installed.

So NIC1 is the shared port for ILO per default.

[Niroa]

that means should i configure eth1 as the outside ip (connected to router).

that is the intilialized shared connector?