- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Hangup while deployment of a ML 110 G2
ProLiant Servers (ML,DL,SL)
1753888
Members
7483
Online
108809
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2005 09:43 PM
12-28-2005 09:43 PM
Hangup while deployment of a ML 110 G2
Hello there
The problem is rather anoying. I have just received our new Storage Server (ML110 G2) connected all the cables etc and booted the system. It runs through the conf of the primary and the secondary OS but it hangs it self after about 90% of the "creating data drive"-task. I tried a quick restore and started the whole procedure again with the same result.
Any solution? can I configure it manualy?
I find it difficult, since all the documentation i got with it starts after this autoconfiguration.
btw: I let it run long enough (about 14h over night).
thanks for the help
The problem is rather anoying. I have just received our new Storage Server (ML110 G2) connected all the cables etc and booted the system. It runs through the conf of the primary and the secondary OS but it hangs it self after about 90% of the "creating data drive"-task. I tried a quick restore and started the whole procedure again with the same result.
Any solution? can I configure it manualy?
I find it difficult, since all the documentation i got with it starts after this autoconfiguration.
btw: I let it run long enough (about 14h over night).
thanks for the help
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-29-2005 08:22 PM
12-29-2005 08:22 PM
Re: Hangup while deployment of a ML 110 G2
When we got our server the hd was bad. It worked partially - but made lots of noise and failed at writing.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP