Help me Config RAID 1 for " HP Smart Array E200 Controller "

[sang_5]

Hello,
My company has just bought a new "HP Proliant Server ML150 G5" and two new SATA Hard Drive ( each have 1TByte in size and don't have any data). How can i config RAID 1 for that two Sata Hard Drive ?

I read the manual but i want to be sure, so that please help me to config RAID 1

I will follow these step to config RAID 1:

- Connecting two Sata Hard Drive to SAS port on "Hp Smart Array E200".
- Install the Firmware of "HP Smart Array E200", Hard Drive, Server
- Install Windows Server 2003 and Device Drivers.
- After installed Windows and device drivers, i use "HP Array Configuration Utility" with mode ACU to config array
Or should i use ORCA to config RAID and then installl Windows Server 2003 ??

Is that correct ? Please corect the fault for me please.

Thank you very much. Hope see your reply soon.

[TTr]

First you use ORCA to configure the raid disks and then you install win2003. You will need to provide the drivers for the e200 when win2003 starts to install.