Help restore firmware on dl160 G5 !!!

[roll77]

Have bought license LO100i advanced. But virtual media KVM didn't work.
At attempt to fill in CPQQ1092.BIN insertions through tftp, there was probably a failure, and after reboot now shows "BMC Does NOT Known Platform ID!" (Look a picture in the appendix).
And in 3 minutes swears on that that doesn't see fans and is switched off. Burns blue LED.
Through manadgenent port access doesn't work, the static address not ping.

CLI through RS232 starts up, but the data "nic1" isn't present.

> Command Line Interface
Copyright 2004-2008 ServerEngines Corporation
All rights reserved.

Login: admin
Password: ********

CLP Session Initiated
/./-> cd map1
/./map1/-> show
status=0
status_tag=success
/./map1/
Targets
log1
firmware
accounts

Properties
name=Hewlett-Packard
oemhp_serial_number =

Verbs
cd
version
exit
show
reset
set
oemhp
help

/./map1/->

How it is possible to make emergency restoration firmware?

[Neoseason]

Quiet old post, but today I have the same problem so why leave it without solution...

In my case I have the same behavior and I have fix it by updating firmware. HP seems to make only ubs key firmware disk (why?!?!?) but you can use the provided rompaq.exe to decompress the present image. In my case I have downloaded SP4484 and in the "flat" directory have CPQQ1092.2AD. Simply user rompaq.exe /D CPQQ1092.2AD CPQQ1092.BIN and update again firmware with bin image.