ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

How to get HP ProLiant ML10 v2 iLOv4 shared NIC working with IEEE 802.3ad link aggregation and Linux

ML110
Occasional Contributor

How to get HP ProLiant ML10 v2 iLOv4 shared NIC working with IEEE 802.3ad link aggregation and Linux

HP ProLiant ML10 v2 Server SN: CN65250CR1

Hello everybody,

I am using the two NICs on the HP ML10v2 in IEEE 802.3ad Dynamic link aggregation with a Cisco SG300-28 switch, however the iLO shared NIC stops working in this mode and I don't know how to fix this under Debian 8 or Redhat 7 and would like some help.

http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c04822945&sp4ts.oid=4154735

Kind regards,

Jelle de Jong
GNU/Linux Consultant.

# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2+3 (2)
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 400
Down Delay (ms): 400

802.3ad info
LACP rate: slow
Min links: 0
Aggregator selection policy (ad_select): stable
Active Aggregator Info:
Aggregator ID: 1
Number of ports: 2
Actor Key: 17
Partner Key: 28
Partner Mac Address: 00:25:84:ce:df:e6

Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 30:8d:99:cc:1e:30
Aggregator ID: 1
Slave queue ID: 0

Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 30:8d:99:cc:1e:31
Aggregator ID: 1
Slave queue ID: 0