HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

How to setup Raid 1?

 
sea021
Occasional Advisor

How to setup Raid 1?

A "HP ProLiant DL140" server want to setup Redhat 9.0 and use Raid 1.
>>HardDisk:ATA-100 (Enhanced IDE),80GB * 2
Which one can ask me how to setup it?
3 REPLIES
Bharat Katkar
Honored Contributor

Re: How to setup Raid 1?

Hi,
If it is Hardware raid, you need to configure your RAID controller and for software mirror, LVM on RedHat will help you configure.

Regards,
You need to know a lot to actually know how little you know
Song Ling_1
Occasional Visitor

Re: How to setup Raid 1?

Can I use the bootable CD that came with my DL-140 to raid the two IDE_ATA drives? There used to be a SmartStart CD that came with each server, has it been replaced by this HP ProLiant DL140 server - Startup, Ducumentation and Utilities CD (one only)?

Thanks!
Symen
Frequent Advisor

Re: How to setup Raid 1?

The DL140 Doesnt support ATA-RAID. It doesnt support internal SCSI disks either, so the only ways to get raid on your system is software RAID (not supported by HP) or a smart array controller with external SCSI drives