ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

How to tell if BBWC is working

 
nasdaq_1
Occasional Contributor

How to tell if BBWC is working

Hello,

I have bought a DL380 G6 and a 512MB BBWC upgrade.

The P410i controller says it has 0MB memory. I can see the battery is blinking (2 blinks then wait for 2 seconds)

Is this normal or should the controller report 512MB? Do i have to wait on battery charge?

Thanks in advance
5 REPLIES
nasdaq_1
Occasional Contributor

Re: How to tell if BBWC is working

I disconnected and reconnected the parts and suddenly it says 512MB, all well I suppose.
marcus1234
Honored Contributor

Re: How to tell if BBWC is working

this happens if cache board is no tclippeed on super tight ,

now do not update firmware to 7xx as it is flaky stay around on firmware 5.4 unless you are missing anything special if so post here i will see what i can do,,



This is how we thank each other in the forum

http://forums11.itrc.hp.com/service/forums/helptips.do?#33

Enjoy:)
marcus1234
Honored Contributor

Re: How to tell if BBWC is working

go in hp tools and run array diagnostic utility and post here i will check it and reply :) on status of raid devices etc.


This is how we thank each other in the forum

http://forums11.itrc.hp.com/service/forums/helptips.do?#33

Enjoy:)
katie1
Frequent Advisor

Re: How to tell if BBWC is working



This is how we thank each other in the forum

http://forums11.itrc.hp.com/service/forums/helptips.do?#33

Enjoy:
marcus1234
Honored Contributor

Re: How to tell if BBWC is working

kalie this is my signature


=============================================
This is how we thank each other in the forum

http://forums11.itrc.hp.com/service/forums/helptips.do?#33