ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Hp Proliant ML-110 G7 raid 1 problem

akino10
Occasional Visitor

Hp Proliant ML-110 G7 raid 1 problem

 

Hello<

 

I have the following problem I'll try to explain :

I have two identical server hardware prolinate HP 110 G7 , on both server have identical 2x500 gb hard drives in a RAID 1. On the server 1 raised win 2008 R2 64bit.

I'll call servers No.1 and No.2 server for ease of explanation.

Server No.1 have 2x500 GB in RAID 1 , position 1 is my hard 500GB to position 2 of the 500gb hard too .

Server No.2 same situation as the server 1 has no one but itself to install is already empty .

Situation me the following : With server No.2 pull both the hard drive and put them aside , then take the No. 1 server hard disk from the position ( drawer ) 2 and insert the server No.2 in drawer no. 2 a drawer No.1 put an empty hard disk drive of 500GB me a RAID 1 not already burst.

Please for assistance or advice on how to solve it .

Thanks In Advance.

2 REPLIES
Torsten.
Acclaimed Contributor

Re: Hp Proliant ML-110 G7 raid 1 problem

What is the goal of this action?

 

You cannot move a single disk from a RAID1 to another server, you need to transfer both disks. This is the rule of drive roaming.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Jimmy Vance
HPE Pro

Re: Hp Proliant ML-110 G7 raid 1 problem


akino10 wrote:

 

Hello<

 

I have the following problem I'll try to explain :

I have two identical server hardware prolinate HP 110 G7 , on both server have identical 2x500 gb hard drives in a RAID 1. On the server 1 raised win 2008 R2 64bit.

I'll call servers No.1 and No.2 server for ease of explanation.

Server No.1 have 2x500 GB in RAID 1 , position 1 is my hard 500GB to position 2 of the 500gb hard too .

Server No.2 same situation as the server 1 has no one but itself to install is already empty .

Situation me the following : With server No.2 pull both the hard drive and put them aside , then take the No. 1 server hard disk from the position ( drawer ) 2 and insert the server No.2 in drawer no. 2 a drawer No.1 put an empty hard disk drive of 500GB me a RAID 1 not already burst.

Please for assistance or advice on how to solve it .

Thanks In Advance.


It depends on what controller you are using in the server. If it isa 'P' serieas Smart Array controller, you can break the mirror and then rebuild the array with new drives

 

This document provides detial

RAID 1(+0): breaking mirrors and rebuilding drives

http://h20566.www2.hp.com/hpsc/doc/public/display?docId=emr_na-c00378986

 

 

 

 

 




__________________________________________________
No support by private messages. Please ask the forum!      I work for HPE

If you feel this was helpful please click the KUDOS! thumb below!