Imaing the drive on a DL380 G3

[Brendan Farrell]

I'm in the process of trying to image a logical drive on my server. I have (6) 36.4 Gig drives on a Smart Array 642 card. I've configured a 2 Gig drive and installed W2K3 OS on it. (I know it's not the recommended size, but I've done this before and it's only a base image that I will modify and deploy at a 4 gig min)
Anywho, Everytime I reboot to image the drive, the error message I get from my imaging software is

"Failed to Open Volume"

Any suggestions? I've tried disabling the on-board SCSI card also. Same error.

[Leon Rosier]

I guess after the reboot the image utility doesn't load the smartarray driver to access the raid disk.

Leon

[markzz]

The g3 loads it's drivers from bios so that's not the problem.
ensure the system and controller firmware is up to date on the g3.
I do this regularly with no problem, if your using Ghost you need to use ver7.5