ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Initial Blade deployment

orven
Frequent Advisor

Initial Blade deployment

I have RDP 3.0 and want to deploy first blade(HP BL20PG3).

I connect one of the GBE2 Switches and it picks up the DHCP bootP.

What about the management of the Enclosure? Can I connect the ILO port at the back of my server to my network and will pick up an IP address too from DHCP.

I want to change Enclosure Name, and all blade names in my RDP priort to deployment.

Please advise,

2 REPLIES
sandeep_raman
Honored Contributor

Re: Initial Blade deployment

Hello orven,

For Ilo to work,it must be configured first.
Select the Ilo BIOS(F8) after Ilo initialisation during POST and configure.

Check
http://forums1.itrc.hp.com/service/forums/bizsupport/questionanswer.do?threadId=1038050
http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1039115

Hope this helps.

SRH
sandeep_raman
Honored Contributor

Re: Initial Blade deployment

Additional information attached.

SRH