HPE Community
ProLiant Servers (ML,DL,SL)
1753781 Members
7463 Online
108799 Solutions
New Discussion

Re: Installation

 
Ayman Altounji
Valued Contributor

‎11-29-2000 04:00 PM

‎11-29-2000 04:00 PM

Installation

During installation, I specify the SCSI adaptor and the driver is loaded but then setup states that it cannot find any hard disks to install on. However, the two 18.2GB SCSI disks are detected during initial boot. Why can't setup see them.
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎11-30-2000 04:00 PM

‎11-30-2000 04:00 PM

Re: Installation

Please make certain the controller with the hard drives attached is listed as " CONTROLLER ORDER FIRST " in the System Configuration Utility .
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.