ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Integrated Lights-Out configuration temporarily unavailable...??

S. Crawford
Occasional Contributor

Integrated Lights-Out configuration temporarily unavailable...??

Hi, This is the error message I receive on a DL380 G4 after POST. It doesn't let me enter via F8. I have already run a firmware update (to v.1.80), but it still acts the same. Does anyone know what to do with this?
3 REPLIES
Oleg Koroz
Honored Contributor

Re: Integrated Lights-Out configuration temporarily unavailable...??

Would you be able to try one of the steps, just for practice?

http://forums1.itrc.hp.com/service/forums/bizsupport/questionanswer.do?threadId=676162
amhakassa
Honored Contributor

Re: Integrated Lights-Out configuration temporarily unavailable...??

Hi S.,

There is an iLO Security Override Switch on the system board. This switch temporarily disables authentication security. To change the state of the iLO Security Override Switch, you must have physical access to the inside of the server so that you can set the switch position on a dipswitch panel on the systemboard to let you access the ILO
Refer this mainetenace and service guide for DL360 G4 server to locate the dipswitch
http://h200007.www2.hp.com/bc/docs/support/SupportManual/c00218204/c00218204.pdf

Refer Pages 67-68 to locate the system maintenance switch (and the switch you are looking at is Switch 1 should set to off)

Regards
Amha Kassa
S. Crawford
Occasional Contributor

Re: Integrated Lights-Out configuration temporarily unavailable...??

The security switch is already set to OFF... Which means security is enabled, but the message still shows up.