ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Integrated Management Display

Ayman Altounji
Valued Contributor

Integrated Management Display

I installed a Windows NT Server 4.0 with Smart Start 5.00 on my ProLiant ML370. The Server has the actual firmeware, NTSSD and Agents installed. After the software installation I installed the IMD to the server. Now I can not connect to the IMD. When I look at the hardware setup it says that there is no IMD installed. The IMD displays only the firmware version. Whats wrong ?

Thanks and bye
Marco Stalder
2 REPLIES
Ayman Altounji
Valued Contributor

Re: Integrated Management Display

Try running the NTSSD again to see if it picks up the IMD, since it was not installed at the time you loaded the software and drivers.
Ayman Altounji
Valued Contributor

Re: Integrated Management Display

I too am having the same problem with the Proliant 7000 using 5.14B Agents. Even running NTSSD a second time does not resolve the issue. Servers (2) are clean installs of Windows 2000 Adv Svr w/SP2 and will be production when configuration is complete. Unfortunately, I refuse to hack the registry to (done on sandboxes) to utilize the Integrated Management Display, unless Compaq has a registry fix that can be downloaded.