ProLiant Servers (ML,DL,SL)
1745793 Members
3906 Online
108722 Solutions
New Discussion

ML 570 G3 - ошибка "ERROR! Adapter Malfunctioning!"

 
nicolaiparkour
Occasional Visitor

ML 570 G3 - ошибка "ERROR! Adapter Malfunctioning!"

Добрый день. Сплавили нам старичка ML570 G3, с небольшой особенностью - при загрузке bios выдает ошибка типа "ERROR! Adapter Malfunctioning!" (первая картинка).


Надпись появляется еще два раза, после чего (минут 15) сервер "проглатывает" ошибку и грузится дальше. При попытке установить ESX 3.5 5U установка зависала на этапе загрузки драйвера "mptscsi_2xx". После перепрошивки BIOS'a ошибка временно исчеза  и я умудрился установить на этот сервер ESX 3.5 5U. Но после переноса в серверную (естес-но с отключением от сети питания) сервер опять начал выдавать эту же ошибку при этом перепрошивка BIOS не помогает.

 

Если его перегрузить, то ошибка не выскакивает и сервер начинает искать устройства типа "Searching for device at HBA 0, ID 0, LUN 0". Так он может искать устройства почти час и только потом грузится (последняя картинка), но ESX всё равно не грузится. 
Также если если оставить его минут 15 (с питанием), то он обратно начинает выдавать ошибку типа  "ERROR! Adapter Malfunctioning!", если меньше ошибка типа  "Searching for device at HBA 0, ID 0, LUN 0".

Надеюсь на помощь по данному вопросу. Заранее спасибо)

 

Google Translate

Good afternoon. Alloy us old man ML570 G3, with a small feature - bios boot gives an error such as "ERROR Adapter Malfunctioning!!" (First picture).

The inscription appears two more times, after which (about 15 minutes), the server "swallows" a mistake and loaded on. When you try to install ESX 3.5 5U installation hangs at the stage of "mptscsi_2xx" driver is loaded. After flashing BIOS'a error extinct, and I managed to install on this server ESX 3.5 5U. But after the transfer to the server (Estes, but disconnecting from the power supply) the server again started to give out the same mistake in this case does not help flashing BIOS.

If it is overload, the error pops up and begins to search for the server type device "Searching for device at HBA 0, ID 0, LUN 0". So it can search the device for almost an hour and then loaded (last picture), but the ESX is still not loaded.

Also, if you if you leave it for about 15 minutes (with meals), it starts to give back to the type of error "ERROR! Adapter Malfunctioning!", If it is less error-type "Searching for device at HBA 0, ID 0, LUN 0".

I hope to help in this regard. Thank you in advance)