HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

ML110 G7, fans go on full, no VGA out or HD activity

 
raid_monkey
Occasional Visitor

ML110 G7, fans go on full, no VGA out or HD activity

After suffering a powower outage, my "trusty" ML110 G7 has a problem, it won't boot :-(

When I connect power to it, the fans come on at full blast, but nothing further happens, no VGA output, no disk activity, and the NIC does not show link.

No response to the power button, even if held in for 9 seconds, the only way to make the noise stop is to pull the power again.

I have tried removing the CMOS battery for 10 minutes and powering up, but no joy.

It is/was my home test box for hyper-v, so no carepaq on it and it is out of warranty.

Is it time to replace it ?

Cheers

1 REPLY
Edwin Eppel
Valued Contributor

Re: ML110 G7, fans go on full, no VGA out or HD activity

If it's just a test box, then strip it down to bare minimum hardware and see if it will post. In addition you can try clearing the NVRAM (system maintenance switch 6).

Manuals listed here