ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

ML110 - How to enable ATA in BIOS

Gilsur
Occasional Visitor

ML110 - How to enable ATA in BIOS

Hi,

I have an HP ML100 with SCSI disk installed. then, i was planning to install this server with mikrotik routerOS. So, i bought an HDD and connected it to ATA slots that available in motherboard. (RouterOS doesnt support SCSI disk.). But, in BIOS, i just found that ATA serial is disabled, but i couldnt enable it.

What should i do?

thanks alot.
4 REPLIES
TTr
Honored Contributor

Re: ML110 - How to enable ATA in BIOS

You did not mention which G the ML110 is but normally you get in the RBSU by hitting the F10 key when during boot up. Then go to the advanced bios screen to see and enable the SATA controller, select boot priority etc..
Gilsur
Occasional Visitor

Re: ML110 - How to enable ATA in BIOS

My Proliant is ML110 (without G). I've entered advanced mode in BIOS, and could see my ATA controller menu was disabled and inactive. I have no idea how to enable it.
TTr
Honored Contributor

Re: ML110 - How to enable ATA in BIOS

> and could see my ATA controller menu was disabled and inactive

You mean you have not navigated in the BIOS settings before? You could not highlight the "disabled" and toggle it to "enabled"?
Gilsur
Occasional Visitor

Re: ML110 - How to enable ATA in BIOS

yup, thats what i mean. ATA configuration was highlighted in gray. I couldnt move my pointer there to change the value.