ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

ML110G5 set to Raid 0 should be Raid 1.

ML110G5 Raid 0 to Raid1
Occasional Contributor

ML110G5 set to Raid 0 should be Raid 1.

I have an ML110G5 which has been configured as Raid 0. Is it possible to convert it to Raid 1. The operating system installed does not have the correct drivers installed.
2 REPLIES
Gary Benavides Meza
Trusted Contributor

Re: ML110G5 set to Raid 0 should be Raid 1.

If you have an smart array controller controller you can Migrate from RAID 0 to RAID 1, using the array configuration utility or the the BIOS of the controller ORCA F8. For embedded SATA I think there is no option to migrate the array.

Regarding the driver issue, you can download the Easy Setup CD for you ML110 G5 which has the drivers that you need:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=3577708&prodNameId=3577715&swEnvOID=1005&swLang=8&mode=2&taskId=135&swItem=MTX-b49f9ab5674248c88e3d5bfb52
ML110G5 Raid 0 to Raid1
Occasional Contributor

Re: ML110G5 set to Raid 0 should be Raid 1.

Can anyone advise how long it takes to build an array of 250GB using the F8 option. I have experience of the Adaptec 1220SA card which is very similar and that takes about 4 or 5 hours.